Builder Sprayed Insulation All Over Furnace In Attic

They also need to seal off areas of air leakage to the outdoors.

Builder sprayed insulation all over furnace in attic.

A case of incompatibility. She asked me to go into the attic to find the roof leaks or where the snow is blowing in through the soffits. The rigid insulation was saturated from condensation. A plenum is the source of combustion air.

A lot of builders and homeowners are going with spray foam insulation because of the airtightness benefits. If you don t have a crawl space or a basement then it can be a challenge to place a furnace on the ground floor of the structure. If the builder says that will cost more then use the money you would have spent on the foam insulation and attic enclosures to do this. Insulation should be rolled out perpendicular to the joists and unfaced rolls should be used.

This puts the furnace in at least semi conditioned space. Batt or rolled insulation or blown loose fill insulation fiberglass or cellulose can be installed on top of old insulation. If the air is not piped in directly to the furnace the attic space would be considered the plenum. The attic floor needs an insulation value of r30 40.

If the furnace is a fuel burning one be sure you provide air for combustion. I found instead a vintage 3 ton ac unit with 1 rigid insulation taped all over it and insulated flex duct snaking all over the poorly insulated attic. A furnace in the attic is a design that works for all homes. In a proper spray foam job a contractor doesn t just spray foam all over the top of your attic and go home.

You might not receive the same air movement benefits if the unit is in a garage either. Otherwise humidity will quickly creep into your attic. Most often the attic is sealed by installing spray foam insulation at the roofline thus bringing the attic inside the building enclosure and turning it into conditioned space directly or indirectly. A while back i wrote about the incompatibility of putting an atmospheric combustion furnace in a sealed attic.

Any existing batt or roll insulation in the attic should have the facing against the attic drywall floor or no facing at all. The attic is the worst place to install hvac equipment and duct work. If you pipe the air in directly to the furnace and it does not use attic space air then you can use sprayfoam. You can build a small enclosure around the furnace with rigid foam insulation then pick up the insulation on the ceiling inside the enclosure.